Track Bar and Endlink Crush Sleeve
Bushing Crush Sleeve (Bolt Sleeve) to be used in conjunction with (2) BSH-H-7087 bushing halves. Select bolt size before ordering, check below for more information. Complete bushing assemblies also available, see: (BSH-CB-7087)
About this product
Bushing Crush Sleeve (Bolt Sleeve) to be used in conjunction with (2) BSH-H-7087 bushing halves. Select bolt size before ordering, check below for more information. Complete bushing assemblies also available, see: (BSH-CB-7087)
Standard endlink bolt size is 12mm for most applications. Some ram 1500 trucks that utilize a welded nut on the frame end of the rear endlinks will use 10mm hardware.
Track bar bolt sizes vary based on jeep model and track bar location. Measure current setup, or reach out to us to determine factory size based on your vehicle.